A Beginner’s Guide To Hitting Irons In Golf

A lot of golfers really like to hit a massive drive off the tee and creates a good shot towards the hole simply by sending over the treetops. It’s better to carry out a long drive together with some company, nonetheless long drives don’t make a sense if you can’t even sink a putt. The short shot with an iron is as important, if not more crucial, than the long shots with a wood. It may look so simple however for newbies, it is probably one of the hardest shot to play. This write-up will help you on how to hit irons effectively.

Step #1: The Right Position of the Body as well as Proper Posture

The first step to successful hits is correct setup regarding your posture and body position. The most common error created by most beginner golfers is bending of the body. Most of untrained golfers makes a bend from the back over the club rather than at the waist. This could adversely influence the swing trajectory; as well as causing a good deal of muscle pain in the back because of increased back muscle use. When playing golf keep the back straight, but not firm. Tilt through the waist allowing for swing through the hips. You should keep your body in an even position on your feet to keep the balance of the body through the swing.

Step #2: The Placement of the ball

An overlooked facet of setting up iron shots is that of ball position. As important as long drives, short shot position must also be considered by golfers. When discussing ball position here, we are referring to its position based on your body setup. The ball being not farther back on the sternum and not far enough beyond your left armpit is the proper ball and body position. Newbies go wrong by playing the shot too far forward that causes to poor slices as well as putts. Attempt to hit the ball again and this time with your sternum straightened out, when the ball heads into the ground when hit.

Step #3: The Takeaway Position

The way wherein the club is retracted and hit through is known as takeaway position. The takeaway position is vital to get a great swing in a play and the success it makes. The strategy utilized when hitting with an iron is the 2-8-2 rule. The first 2 in the rule is the first two inches in a takeaway in which the club travels straight back. It is important to move the body (arm, legs and shoulders) in sync. In eight inches, the club makes an upward direction curve and the wrist must not move. Finally, at the twelfth inch, the wrist turns placing the shaft horizontal to the ground. The hands must level to the shoulder height and the shoulder should be tight. Right after executing the takeaway position, follow along the target line and hit the ball by a square iron face.

Step #4: Think About The Course

It is also essential to think about the layout of the swing. Adjustments to be made during a takeaway or even swing depends on the surface being played. When the ball is to be played on a downhill slope, it is best to complete a downswing at the point where the ball will fall towards the hole. For example, a green with a slight downhill would be best performed at a slight curve to allow for gravitational pull. It might also be worthwhile to remove any obstructions within the path that can encumber the shot.

The post A Beginner’s Guide To Hitting Irons In Golf appeared first on Heron Creek Golf Club.

http://ift.tt/2cJyl2M

Advertisements

Author: heroncreekgolfcourse

Heron Creek Golf Club is the home of an 18 hole, par 71 golf course. A relaxing round of golf is what you can expect from our golf course. There are many hazards on our course but a great day of golf can be had by all level of golfers.

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out / Change )

Twitter picture

You are commenting using your Twitter account. Log Out / Change )

Facebook photo

You are commenting using your Facebook account. Log Out / Change )

Google+ photo

You are commenting using your Google+ account. Log Out / Change )

Connecting to %s